Command Start CS-580i FM Guia de Instalação descarregar pdf (Página 17)

Installation Guide P. 17

once again). Please note that most OEM systems will not rearm the Alarm while the Engine

is running, but will still lock the Doors.

Smart Secure Lock

If the vehicle is initially locked, upon remote START the System will trigger an unlock pulse

and a disarm pulse before the Engine is started. The System will

LOCK again when the

Engine is running, and

LOCK once again 4 seconds after shut-down.

If the vehicle is initially unlocked, upon remote

START the System will start the Engine and

arm the Starter Kill and Alarm, but the Doors will not be locked or unlocked at any moment

of the sequence.

Lock Pulse Duration

The duration of the Lock and Unlock pulses can be configured as follows:

• (Default) 7/10-sec. LOCK and 7/10-sec. UNLOCK pulses

• 4-sec. LOCK/UNLOCK pulses to control vacuum Door Lock systems

• A single 7/10-sec. LOCK pulse and two 1/4-sec. UNLOCK pulses

for double-pulse disarm/unlock systems.

• 1/10-sec. LOCK and 1/10-sec. UNLOCK pulses

Engine Run Time

Use this Function to configure the length of time the Engine will be left running under remote

control. The System will allow the Engine to run for either 4, 15 or 25 min. in Gas Mode and

9, 20 or 30 min. in Diesel Mode. Standard default Run Time is 15 minutes in Gas mode and

20 minutes in Diesel mode.

Open Zone Notification

This feature will warn the user when a Door is left open: upon the arming of the System, a

10-sec. notification delay will take place, after which the Siren will chirp 3 times if an open

door is detected.

Starter Kill (Installation)

The System is equipped with a selectable Passive or Active-arming Starter Kill circuit that

will prevent the vehicle from being started with the Ignition Key when the System is armed.

The Starter Kill wire will provide a constant 500-mA. negative output when the system is

armed (locked by remote control) and can be connected to an external Starter or Ignition

interrupt relay.

The Starter Kill circuit follows the arming function of the Alarm and therefore can be set to

arm in either Passive Mode or Active Mode.

Passive or Active Arming

• Active Arming: the Alarm and the Starter Kill will not arm automatically. Press the

LOCK button to arm and the UNLOCK button to disarm it.

• Passive Arming: the Alarm and the Starter Kill will arm automatically if it is not armed

by remote within a 30-sec. delay. Press UNLOCK to disarm.

• Passive Arming without Siren Mute. Press UNLOCK to disarm.

• Disarmed Notification: See description below.

Disarmed Notification

This feature will notify the user when the vehicle is left disarmed: (1) after Ignition is turned

off and the Ignition Key is removed from the Ignition Switch, or (2) when the System is

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Comentários a estes Manuais

Sem comentários

Command Start CS-580i FM Guia de Instalação Página 17

Comentários a estes Manuais