Command Start CS-580i FM Guia de Instalação descarregar pdf (Página 18)

P. 18 Installation Guide

disarmed after being previously armed, the opening or closing of a Door will start a 10-sec.

timer, after which the Horn or Siren will chirp once, if the vehicle was left unprotected, to

warn the user. Pressing

LOCK or UNLOCK before the 10-sec. delay elapses will cancel this

warning.

Siren Mute

When the Siren is sounding, pressing the UNLOCK button will stop the Siren. Note that this

will not unlock or disarm the vehicle.

Horn / Siren Mode

The System can be configured to use either the Siren or the Horn for sound signals and

alarms.

Siren or Horn Chirps

The Siren can be configured to give the following signals:

Warning Chirps:

Arming and disarming the car (LOCK or UNLOCK) will not cause the Siren to chirp. While

the vehicle is being armed, the Siren will chirp 3 times if a Zone is active. After the

Alarm is set off, disarming the vehicle will cause the Siren to chirp 4 times.

Full Chirps:

Pressing the LOCK button will lock all Doors, arm the system and

• cause the Siren to chirp 1 time if all Zones are inactive.

• cause the Siren to chirp 3 times if a Zone is active.

Pressing the UNLOCK button will unlock and disarm the vehicle and:

• if no intrusion was detected, the Siren will chirp 2 times.

• if an intrusion was detected, the Siren will chirp 4 times.

Open Zone Notification (see below):

If a Door is detected as open 10 sec. after arming, the Siren will chirp 3 times.

Chirps disabled: the Siren will not chirp under any circumstance.

Shock Sense and Warn-away Sense

Your System can react to a full shock by triggering the Alarm; it can also respond to a lighter

shock (30 % of the strength of a full shock) by giving a Warn-away: the Siren will chirp but

no Alarm condition will be triggered. However, when the Engine is running after a remote

start, the Shock Sensor will not trigger an Alarm condition, although it will still produce

warning chirps if Warn-away Sense is enabled.

Note

Although the Shock Sensor may not trigger an Alarm condition after remote starts, the

Door Zones and the Hood Pin-switch may generate one: the Door Zones and the

Hood Pin-switch are not disabled in any way after remote starts.

Resetting the System

The System is equipped with a reset function that allows the installer to erase all Transmitter

codes from memory and return all the Programming Options to the factory default values.

Resetting the System is not a required process. Most of the time, you can avoid resetting by

fixing the issue directly at the root of the cause.

1. Flash the Hood Pin switch (see Table 1)

– Once inside Programming Mode, you have 13 seconds to complete the next step.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Comentários a estes Manuais

Sem comentários

Command Start CS-580i FM Guia de Instalação Página 18

Comentários a estes Manuais