Command Start CS-580i FM Guia de Instalação descarregar pdf (Página 6)

P. 6 Installation Guide

5 YELLOW

(+) 12 V Parking

Light output

This wire provides a +12 V output and must be connected on the

vehicle to the Parking Lights wire that tests +12 V when the Light

switch is in the ON position.

Note: ensure that the voltage does not decrease or increase when

the dimmer control switch is turned. If the voltage goes up or down,

find another Parking Light wire.

12-pin Accessories Harness

Wire Colour Function Description

1 BLUE

(–) Trunk /

AUX 3

output

500 mA negative output. This output can be used to control

the Trunk release (1-sec. pulse), or it can be set to operate

as a constant output as long as the TRUNK button is held

pressed (for Sunroof or Window closure)

2 BROWN

(–) Lock

output

Programmable 500 mA negative output: 1/10-sec., 7/10-

sec. or 4-sec. pulse

3 GREEN

(–) Unlock

output

Programmable 500 mA negative output: 1/10-sec., 7/10-

sec., 4-sec. or double 1/4-sec. pulse (ON 250 ms, OFF

500 ms, ON 250 ms).

WHITE /

BROWN

(–) Rearm

output

500 mA ground signal when the Doors are locked by

remote control. This wire will go to ground 1/2 sec. before

the LOCK pulse, and go out 1/8 sec after LOCK. The wire

must be connected to the OEM Arm wire (usually the Door

Pin).

Note: The System will also give a Rearm pulse on this wire

when it shuts down the vehicle after a remote start.

WHITE /

GREEN

(–) Disarm

output

500 mA ground pulse when the Doors are unlocked by

remote control. Connect to the OEM Disarm wire of the

vehicle.

Note: The system will also give a Disarm pulse on this wire

before every remote start.

This input should be used in vehicles with positive-

switching Door pins or Dome Light circuits. Connect to the

Dome Light wire that tests +12 V when a Door is open.

BLUE /

WHITE

(+) Positive

Door input

Caution! The installer should use either the positive or the

negative Door input. Never use both of them

simultaneously.

WHITE /

ORANGE

(–) Starter Kill

output

(armed

output)

This wire will provide a constant 500 mA output when the

system is armed (locked by remote control). It can be

connected to an external Starter Interrupt Relay.

This wire should be connected to a Single Pole Double-

Throw Relay: this wire will connect to Pin 85 on the Relay,

and Pin 86 will be connected to the Ignition wire.

The Starter Kill output becomes active during remote starts.

One benefit of the Starter Kill is the Anti-Grind feature.

Once the vehicle has been remote started, the Anti-Grind

prevents the Starter Motor from re-engaging when the

Ignition Key is inserted in the Ignition Switch and

accidentally turned to the CRANK position.

8 ORANGE N/A This wire is not used.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comentários a estes Manuais

Sem comentários

Command Start CS-580i FM Guia de Instalação Página 6

Comentários a estes Manuais